Sewing Machine Cover Tutorial

I've never written a tutorial before, but after posting on Facebook that I'd been making a sewing machine cover my lovely daughter in law asked me how I did it.
I wanted to try a photo tutorial and as I had 15 covers to make for sewing machines at work, I decided to take some photos and do a tutorial!

Here's the cover I was replacing - they get a bit of a hammering with all the classes that use them. And here's the sewing machine - it's a Bernina 1008, with a handle at the top. I was able to use the existing cover as a pattern, which I drew onto newsprint (thin paper).

I cut out 7 pieces (measure to suit your machine)

• 2 identical pieces for front and back
• 1 piece for pocket (same width as the front, but not as long)
• 2 identical side panels
• 2 identical top panels

Step 1 - Creating the top and side panels

The space for a handle is created by using the two small panels, attached to the side panels.

Turn over and stitch along one long edge of the 2 top panels

Lay the top panels right sides together on the narrow edge side panel, leaving a gap for the handle.

Stitch the panels and stitch across the gap for added strength. Do this at both ends

Turn the  side panel edge under and top stitch it for added strength.

 

Here's my top stitching.



 

Step 2 - creating the pocket

Fold over a long edge of the pocket - I folded it over twice - and stitch.

I added a second row of stitching for strength. The foot pedal is stored in the pocket so I wanted to make it strong.

Place the pocket right sides together with the front panel. Overlap them about 6 cm and stitch.

Fold the pocket back on itself.

Add a row of top stitching at the bottom of the pocket. Again this is for strength.

Sew the pocket to the front panel along the side seams. I used a very small seam allowance so the stitching wouldn't show when I attached the side panels.

 

Step 3 - putting it all together.

This is a bit fiddly but just take your time and you'll get there!

 

Pin the front panel to the side and top panels, right sides together. Obviously you have to get round the corner. Pin it as best you can.

Stitch up to the first corner, stopping about 1.5 cm from the edge.

Make sure your needle is in the fabric, lift your presser foot and turn the fabric 90 degrees.

You should now have your sewn seam running horizontally. The unsewn edges will be headed in two different directions - this is the fiddly bit - we need to get them headed in the same direction!

Pinch the excess fabric  and move it across so that the top layer matches the bottom layer. You will get a little bunching around the needle - don't panic it will disappear when you sew it!

Fold the fabric out the way. Lower your presser foot. There will be some bunching around your needle, but start sewing slowly, or use the hand wheel for the first couple of stitches, and you should be able to ease that out.

Carry on sewing in a straight line until you get to the next corner, where you have to do the same again!
 

You will need to repeat those stages again to attach the back panel.

 

Step 4 - finishing off!

Fold the bottom edge over twice and stitch.

Taa-dah! It's finished! You can see how the space for the handle works, and the pocket being used for storing the foot pedal.

Thanks to activity week I had the luxury of a whole day sewing - no food lessons to prepare and no-one asking me to re-thread their needles! I managed to make 14 of these in about 5 hours - they aren't all the neatest, but they will do the job!

You've probably noticed that I pinned very little - this was for the sake of speed, and I would advise that you pinned things so they didn't slip. Pressing edges that you are turning over will also give you a neater finish.

 

Please leave any queries or questions and I'll try and answer them!